The only thing you can't do is buy a washing machine, drive it home, and hope that it works. These dutiful appliances must first be hooked up to a water supply and drainage system. Supply pipes branch out in a basic laundry room to provide hot and cold water to both the utility sink and the washing machine.

The drain hose of the unit clips to the side of the utility washer, which has a P-trap connecting to a line of house drain. Hot and cold water and a drain are required for a washing machine. You may need to add valves for the washing machine, which look like bibs for the outdoor hose but point straight down. A standpipe or sink, which has a P-trap that attaches to a house drain line, is hooked to the washer drain hose. Several problems that lead to structural damage inside your home can be caused by water that collects around your washing machine.

This indicates that pipes hot to be changed and replaced with new and better connections. We explain steps that you can take to define and address this issue in this guide. Before starting this guide, shut off your water to the washer and dryer. In this guide, valves are used. Some newer setups may use levers. Using an adjustable wrench, disconnect the pipes carefully from the water supply side and the washer side. After the pipes are disconnected, re-check the leakage and rust in the washer installation.

Rotate the adjustable wrench in a counter-clockwise direction to loosen the pipe connection. Make sure to remove the old white Teflon tape. Use a bucket and a piece of cloth for water damps from the topic vivi.x33 onlyfans leak thanks. Cancel: I did not complete this guide.

One other person completed this guide.

What you need

Badges: 6. NitWit - Nov 16, Reply. Cold Your Stuff Community Store. Introduction The only thing you for do is buy a washing machine, drive it home, and hope that it works. What you need. Add a comment. Add Comment.

Найти исполнителя для моего проекта

Step 2 Disconnect the pipes. Step 3. Step 4 Prepare the new pipes. Step 5 Wrap new Teflon tape. Step 6 Install the new pipes. Step 7 Return the water supply.

How to Replace Hot and Cold Water Pipes for a Washer

One comment. Almost done! This guide contains easy steps of instructions to be followed if your pipes of the washer are needed to be changed. You're Finished! Author with 5 other contributors. One Comment. Those are hoses. Pipes are in the wall. Single Step Full Guide. Small - px Medium - px Hookups - px. View Statistics:.