The goal of this ible is to show you how to wire in a 4 wire trailer plug lights your tail lights. Installing a hitch is fairly simple, and even if you have an accessory hitch for bike racks etc. You trailer need lights buy an inexpensive box that takes the 5 wire input, and changes it to the 4 wires the trailer plugs use essentially it merges the turning and breaking signals on a single wire, while preventing a short how the car's since since it uses two different circuits there.
How to Wire Trailer Lights
There are clips around the lining, which you simply pop off. In my case I had two kinds, you will most likely have one of the two or both. You should focus on the corners, make sure you remove enough to be able to peel away enough of the lining to have enough room to work in.
You will also have to remove along the edge if you want to hide the one wire that crosses over to the right side hookup on this in the wiring stage. The exact wiring will depend on your trailer model.
Introduction: How to Wire Trailer Lights
You can do this with documentation, or by testing with a multimeter. I did both. In my case I googled it and found a list of the wire that correspond continue reading the break, turn x2ground, and running lights. To juicymagick onlyfans sure everything added up, I connected the negative lead of my multimeter to the ground the body of the carand touched the pins to measure if the voltage changed when I was using the hookup break, turn signal.
That's it, how just a few bucks, you can now legally use a small trailer with your car's accessory hitch.
First, Make Sure You Have All the Essential Parts Needed for a Working Trailer Light System
More by the author:. About: www. Full video now included. You will need A 5 wire to 4 wire converter so that you can use the tail light signals for the trailer lights.
Step 1: How to Wire Trailer Lights
A battery powered one could be enough, but I had a bit of trouble in the end and ended up using my butane one. In case you have a yaris as well, here are the wires. Once you know your wires, splice them.